Cummins — 3666003

Flywheel Housing, REPTO C Series Page 16-30 Section 16 - Mounting Adaptations - Group 16 Measure shaft end play. Output Shaft End Play mm in 0.00 MIN 0.000 0.03 MAX 0.001 Check the output shaft rolling resistance with a torque wrench. Rolling resistance must be between 0.6 to 1 N•m [5 to 10 in-lb]. If the rolloing resistance is not within specification, remove the output flange and smaller bearing. Add or subtract shims to obtain the correct rolling resistance. NOTE: Adding more shims will decrease the resistance and removing shims will increase resistance. Any combination of shims can be used.

Once the correct rolling resistance is obtained, remove the output flange and install a new oil seal. Press the oil seal flush with the housing surface.