C Series Flywheel Housing, REPTO Section 16 - Mounting Adaptations - Group 16 Page 16-31 Apply pipe sealant, Part Number 3375066, to the output flange capscrew and under the washer. Install the output flange flat washer and capscrew. Tighten the capscrew. Torque Value: 205 N•m [ 150 ft-lb ] Install a new o-ring on the bearing housing cover. Use clean vegetable oil to lubricate the o-ring. Install and tighten the cover and four capscrews. Torque Value: 18 N•m [ 14 ft-lb ] Insert a new spacer ring into the bore of the idler gear. Push it in until it snaps into place in the center groove.