Flywheel Housing, REPTO C Series Page 16-32 Section 16 - Mounting Adaptations - Group 16 Use Lubriplate™ 105 or equivalent to lubricate the bearing outer races. Press the two new bearing outer races into the bore of the idler gear. The larger side of the taper must face toward the outside of the gear. NOTE: Do not interchange individual parts that make up the idler gear bearing assembly. Rebuild the idler gear with bearings that are packaged together. Keep the two roller bearing assemblies and the spacer ring with the idler gear. Install Install rectangular seal and lubricate with Lubriplate™ 105, or equivalent.
Apply a continuous bead of ThreeBond™, or equivalent, around all capscrew holes on the mounting surface of the flywheel housing.