Cummins — 3666003

C Series Flywheel Housing, REPTO Section 16 - Mounting Adaptations - Group 16 Page 16-33 The component weighs 23 kg [50 lb] or more. To avoid personal injury, use a hoist or get assistance to lift the component. WARNING Inspect the rear face of the cylinder block and flywheel housing mounting surface for cleanliness and nicks or burrs. Install the flywheel housing over the two ring dowels. NOTE: Be sure the sealing ring is not damaged during installation. Install the capscrews and tighten with the sequence shown, using offset wrench, Part Number 3823892, for capscrews hidden from view. Torque Value: 60 N•m [ 45 ft-lb ] NOTE:

Before installing the idler gear, measure the flywheel housing bore and face alignment. Refer to Procedure 016-006. Fabricate a sleeve from 38.10 mm [1.50 in] PVC (or equivalent) to the following dimensions. Length - 25.4 mm [1.0 in] Slot - 12.70 mm [0.50 in]