Cummins — 3666003

Flywheel Housing, REPTO C Series Page 16-34 Section 16 - Mounting Adaptations - Group 16 NOTE: The outer bearing races of new replacement gears are already pressed into the gear. Apply a thin film of Lubriplate™ 105 or equivalent on the outer races and the bearings. Install the bearing and spacer into the idler gear. Use a plastic sleeve to hold the bearing assembly together when installing the idler gear assembly. Apply a thin film of Lubriplate™ 105 or equivalent into the idler shaft bore of the housing and on the idler shaft. Install the idler gear assembly into the flywheel housing. Hold the idler gear and bearing in place and remove the plastic sleeve.

Use clean Lubriplate™ 105 to lubricate the idle shaft o- ring and install the o-ring into the shaft. Hold the gear assembly in place and insert the idler shaft through the housing and idler gear bearings. NOTE: Do not use a hammer when installing the idler shaft and capscrew or the part can be damaged. Apply Lubriplate™ 105 under the head of the idler shaft capscrew. Insert the capscrew through the idler shaft. Tighten the installation capscrew with a torque wrench. NOTE: The toque needed to draw the idler shaft in place must not exceed 88 N•m [65 ft-lb]. If installation torque exceeds this amount, it is an indication of misalignment between the bore and the shaft.

Remove the idler shaft and install it again.