Marine Vibration Isolator C Series Page 16-46 Section 16 - Mounting Adaptations - Group 16 Install Set the new isolator in place. Check that the isolator is properly aligned. Reference the Initial Check section in this procedure for alignment information. Set the adjusting nut at the approximate height of the isolator removed. Replace other isolators that need to be changed using the same technique. Install the washer and top nut. Lower the engine so that its weight is fully supported by the isolators. Verify that the isolators are loaded evenly. Depending on the configuration of the engine, the weight may not be evenly distributed on all four corners.
The engine will be heavier at either the front or back, depending the on configuration. Therefore, the isolators on the heavier end will be compressed more. Check the snubber gap on all isolators. If only one isolator or two isolators that are diagonally across from each other are significantly more compressed, the loading on the isolators is unbalanced. Adjust the loading on the isolators by raising or lowering the adjusting nut on the stud. Raising the adjusting nut will increase the load. Lowering the adjusting nut will decrease the load. The engine should be lifted and the load removed from the isolator before moving the adjusting nut, to prevent damage to the threads.
Finishing Steps Batteries can emit explosive gases. To reduce the possibility of personal injury, always ventilate the compartment before servicing the batteries. To reduce the possibility of arcing, remove the negative (-) battery cable first and attach the negative (-) battery cable last. WARNING Align the propeller shaft. Refer to Procedure 016-025 in Section 16. Connect the battery cables. Refer to the OEM service manual. Start the engine and check for proper operation.