C Series Marine Vibration Isolator Section 16 - Mounting Adaptations - Group 16 Page 16-45 Remove This component or assembly weighs greater than 23 kg [50 lb]. To prevent serious personal injury, be sure to have assistance or use appropriate lifting equipment to lift this component or assembly. WARNING The engine needs to be supported before removing the isolators. The amount of space available will determine the best method for this support. Remove the top nut from the isolator's adjusting stud. Remove the bolts or capscrews retaining the isolator base. Raise the engine if necessary to facilitate the removal of the isolator.
Make sure that any equipment used for hoisting of jacking the engine is capable of handling the weight of the engine and marine gear. Any engine component used for attaching or support such as the lifting brackets or engine supports must be correct for the engine. Reference the appropriate manual for General Engine information in Section V for the engine weight. Remove the isolator. If reusing the isolator, mark the position of the isolator relative to the engine to make sure of installation in the same location. If replacing the worn or damaged isolator with a new isolator, measure the height of the adjusting nut on the stud to assist in setting the new isolator adjusting nut height.
Inspect for Reuse Inspect the vessel stringers or engine bed to make sure they have not been damaged and that they can continue to support the weight of the engine. This is especially true of stringers constructed of wood, wood core, or hollow fiberglass. Inspect the mounting holes in the stringers or the engine bed for damage. If the stringers, engine bed, or mounting holes need to be repaired, contact an OEM qualified repair location.