honda — 2000 -1996

Repair instruction Preparation before starting the repair Fitting instructions 1-1. Remove the undercover on the rear side. 1-2. Remove the water pilot tube and carburetor drain tube ! Because this work involves the changing of the fuel tubes, fuel remaining in the related parts can leak. Be careful not to spill fuel on the engine, using a shop cloth to stop the fuel leaking is advised. ! Before starting work, make sure that there is no flame nearby and the engine is not hot. (Remove the terminals if a battery is equipped.) ! Be careful not to allow dust to enter the fuel system during replacement work. !

Remove the fuel connector for the fuel tank before starting any work on the fuel system. from the undercover on the right side. 2.Remove the engine side stopper, and then remove the fuel chamber stay (not reusable). 3-1. Remove the fuel tubes B and C of the fuel pump, and remove the fuel pump from the unit. [Note] Replace the O-ring of the fuel pump with the supplied O-ring. 3-2. Invert the direction of the fuel pump by 180 degrees, and install it. Tightening torque of 6 x 22 flange bolt: 12 Nm 4-1. Pull out the oil level gauge, and insert the 11 x 20 mm tube onto the oil level pipe as far as it will go. Engine side stopper Before replace Before replace me After replac After replac eme