honda — 2000 -1996

4-2. Insert the slit of the fuel chamber suspension of the subassembly’s kit onto the oil level pipe. 4-3. Similarly insert the second 11 x 20 mm tube into the oil level pipe, and install the oil level gauge. 5-1. Install each fuel tube of the kit. Reuse the tube clip and clamp. 5-2. Install the fuel tube B on the joint on the upper side of the pump. 5.3 Adjust the chamber position so that clearance between the oil filter cartridge and fuel chamber will be approx 15 mm. Note - 15 mm as shown in the illustration below, and then secure the chamber with a tie wrap. After securing it with the tie wrap, cut off the surplus end. 6.

Mount a new 6 mm washer on the engine side stopper before installation. Tightening torque of engine side stopper: 10 Nm 7. Installation of water check tube and carburetor drain tube Installed position and direction Insert the chamber with its direction as shown in illustration. Apply soap suds when installing the 11 x 20 mm tube and rubber suspension. Be sure to insert them as far as they will go without any clearance. Oil level pipe Suspension slit Tube B for upper joint Tube C for lower joint Oil filter cartridge Fuel chamber 15 mm Tie wrap 6 mm washer Engine side stopper