I000983 Fig. 95. I003578 Fig. 96. I003597 Fig. 97. 919 .. 0101-1000 925 .. 1001- 934 .. 0101-1000 919 .. 1001- 928 .. 0101-1000 934 .. 1001- 922 .. 0101-1000 928 .. 1001- 922 .. 1001- 931 .. 0101-1000 925 .. 0101-1000 931 .. 1001- F08 Calibration taking too long (more than 30 seconds) F01 Preliminary conditions not satisfied F09 User terminated calibration with ESC F10 Plausibility: "Centre position" signal F13 Plausibility: Calibrated values match Move the steering wheel to its centre position and make sure the front wheels are completely straight If calibration is completed without errors, O.K. appears and the new sensor settings are saved. N OTE :
Settings are only transferred when the ignition key has been turned to "0" position. (Wait for at least 15 seconds before switching on the ig- nition again!) If incorrect values are detected or the conditions are not met, an message appears ERROR N OTE : The fault code is displayed from end-of-line pro- gram (EOL) 7.60 onward (Autumn 2007) F12 Plausibility: "Right stop" signal N OTE : Release hand brake and advance the tractor slowly, keeping the wheels straight. F11 Plausibility:
"Left stop" signal Press "Return" to confirm 0000 - Overall system/tractor F - Setting and calibrating Fault code Cause 260 T000377 Version 3 21-04-2009 2401 = calibration code FXX = fault code F - Setting and calibrating Fault code Cause F01 Preliminary conditions not satisfied F08 Calibration taking too long (more than 30 seconds) F09 User terminated calibration with ESC F10 Plausibility: "Centre position" signal F11 Plausibility: "Left stop" signal F12 Plausibility: "Right stop" signal F13 Plausibility: Calibrated values match