0000 - Overall system/tractor F - Setting and calibrating I002516 Fig. 105. I003578 Fig. 106. I003598 Fig. 107. 263 T000808 Version 2 04-09-2009 F03 Manual steering wheel actuation during calibration F11 Plausibility: Signal in direction "steering to left" F12 Plausibility: Signal in direction "steering to right" F06 No movement in direction "steering to left" F07 No movement in direction "steering to right" F01 Preliminary conditions not satisfied F09 User terminated calibration with ESC If calibration is completed without errors, O.K. appears and the new sensor settings are saved. N OTE : Settings are only transferred when ignition key has been turned to "0" position.
(Wait for at least 15 seconds before switching on the ig- nition again!) If incorrect values are detected or the conditions are not met, an ERROR message appears N OTE : The fault code is displayed from end-of-line pro- gram (EOL) 7.60 onward (Autumn 2007) 919 .. 0101-1000 925 .. 1001- 934 .. 0101-1000 919 .. 1001- 928 .. 0101-1000 934 .. 1001- 922 .. 0101-1000 928 .. 1001- 922 .. 1001- 931 .. 0101-1000 925 .. 0101-1000 931 ..
1001- F02 Front wheels are not straight F08 Calibration taking too long The following image is displayed Fault code Cause 2403 = calibration code FXX = fault code F - Setting and calibrating Fault code Cause F01 Preliminary conditions not satisfied F02 Front wheels are not straight F03 Manual steering wheel actuation during calibration F06 No movement in direction "steering to left" F07 No movement in direction "steering to right" F08 Calibration taking too long F09 User terminated calibration with ESC F11 Plausibility: Signal in direction "steering to left" F12 Plausibility: Signal in direction "steering to right"