Fendt 900 Vario COM III — 9 Calibration code 6034 (rear PTO clutch)

I000760 Fig. 108. I000761 Fig. 109. 10. Calibration of rear PTO coupling time The load-dependent start-up of the rear PTO is stored in the A050 - ECU, basic control unit. The rear PTO clutch is calibrated to adapt the coupling operation to the implement concerned. The A050 - ECU, basic control unit can be taught, i.e. after a few coupling operations it adapts the PTO start-up to the respective implement. N OTE : For optimum adaptation of the PTO start-up, calibrate the rear PTO with the implement connected. 919 .. 0101-1000 925 .. 1001- 934 .. 0101-1000 919 .. 1001- 928 .. 0101-1000 934 .. 1001- 922 .. 0101-1000 928 .. 1001- 922 .. 1001- 931 .. 0101-1000 925 .. 0101-1000 931 ..

1001- If fault messages are displayed, the faults must be confirmed one by one. 9 Calibration code 6034 (rear PTO clutch) D ANGER : During calibration, the PTO may rotate slightly. Follow all necessary safety procedures. Calibrating the rear PTO clutch Important: The following preparatory steps must be carried out.

Press "ESC" to confirm the warning and fault messages displayed on the A007 instrument panel Press one of the buttons repeatedly until the symbol (A) flashes Press "Return", the first main menu appears in the multiple display Press "Return", the second main menu appears in the multiple display Preselect any PTO setting (540/540E/1000) 0000 - Overall system/tractor F - Setting and calibrating 264 T000332 Version 2 04-09-2009 Hand brake applied Start engine. F - Setting and calibrating