Fendt 900 Vario COM III — 15 Calibration code 4007 (transmission ratio characteristic)

0000 - Overall system/tractor F - Setting and calibrating I000760 Fig. 158. I000554 Fig. 159. 283 T000399 Version 3 21-04-2009 No error messages from speed sensors (B010 sensor, engine speed and B014 sensor, hydrostatic collecting shaft) Range selector in neutral (normal after calibration of the travel range selector (code 4003)) Manually set the transmission to neutral via the emergency operation if necessary. 15 Calibration code 4007 (transmission ratio characteristic) Neutral switch not in neutral (LED off). Transmission is engaged ("ACTIVE STATIONARY") If fault messages are displayed, the faults must be confirmed one by one.

The engine speed must not drop below 1400 rpm during calibration 16. Calibrating the transmission ratio characteristic Important: The following preparatory steps must be carried out. Press "ESC" to confirm the warning and fault messages displayed on the A007 instrument panel 919 .. 0101-1000 925 .. 1001- 934 .. 0101-1000 919 .. 1001- 928 .. 0101-1000 934 .. 1001- 922 .. 0101-1000 928 .. 1001- 922 .. 1001- 931 .. 0101-1000 925 .. 0101-1000 931 .. 1001- Transmission oil temperature approx.

40°C "Transmission in ACTIVE STATIONARY" display Tractor stationary (below 0.01 km/h) Engine speed 1600 rpm +/- 30 Press "ESC" to confirm Clutch pedal not depressed Hand brake applied Start engine F - Setting and calibrating