0000 - Overall system/tractor F - Setting and calibrating I003371 Fig. 201. I002355 Fig. 202. Description In addition to GPS navigation, the Auto-Guide system also includes a dynamic measurement unit DMU (gyro compass) The sensors inside the DMU measure angular rates and acceleration, in order to determine the precise orientation of the vehicle (over 70 times a second). This enables the Auto-Guide system to measure roll, pitch and yaw of the tractor very precisely and can guide the tractor very accurately along the path. The DMU (gyro compass) has been especially developed for vehicles that are subject to vibrations.
The DMU (gyro compass) does not have any moving parts 301 T001196 Version 1 07-11-2007 20 Auto-Guide system: calibration of roll bias (DMU) (only with OmniStar Following fitment of the Auto-Guide system into the tractor (after ordering and commissioning of the patch) Calibrating for roll bias Roll bias calibration must be carried out under the following circumstances: Periodically (at the beginning of the season, or on a monthly basis) When the A058 Auto-Guide TopDock is transferred to another tractor If the Auto-Guide system has been inactive for a long period the DMU (gyro compass) roll bias must be calibrated. N OTE :
When operating the Auto-Guide system with the OmniStar VBS patch, calibration of the roll bias is not nec- essary. The DMU (gyro compass) is built into the A058 Auto-Guide TopDock 919 .. 0101-1000 925 .. 1001- 934 .. 0101-1000 919 .. 1001- 928 .. 0101-1000 934 .. 1001- 922 .. 0101-1000 928 .. 1001- 922 .. 1001- 931 .. 0101-1000 925 .. 0101-1000 931 .. 1001- When operating the Auto-Guide system with the patch: When the DMU (gyro compass) is replaced When using the OmniStar HP patch HP or basic station) Basic station (local base) When using a basic station DMU (gyro compass) OmniStar HP or F - Setting and calibrating