Fendt 900 Vario COM III — 20 Auto-Guide system: calibration of roll bias (DMU) (only with OmniStar HP or basic station)

0000 - Overall system/tractor F - Setting and calibrating I003504 Fig. 207. 303 T001196 Version 1 07-11-2007 Turn around at the end of the wayline and align wheels in the same wheel tracks going the opposite direction. Move the tractor forwards and switch on the automatic track guide. Maintain a speed of approx. 7 km/h . Drive for at least 100 m along the way line. At the end of the second run, turn the tractor around again and align wheels in the same wheel tracks. Wait at least 30 seconds. In these 30 seconds the Auto-Guide system performs a mean roll bias calculation. On flat, reasonably level ground, align the tractor at the start of the wayline.

Move the tractor forwards and switch on the automatic track guide. Maintain a speed of approx. 7 km/h . Drive for at least 100 m along the way line. Set the following parameters on the A059 Auto-Guide terminal: Implement width = 10 m Implement offset = 0 m Way line offset = 0 m 919 .. 0101-1000 925 .. 1001- 934 .. 0101-1000 919 .. 1001- 928 .. 0101-1000 934 .. 1001- 922 .. 0101-1000 928 .. 1001- 922 .. 1001- 931 .. 0101-1000 925 .. 0101-1000 931 .. 1001- Procedure F - Setting and calibrating