Fendt 900 Vario COM III — 2 Measuring transmission pressure

In the event of complaints regarding Vario tractors that indicate malfunctions in the transmission or are gener- ally captured under the heading "Power", proceed as follows. It must be determined whether the complaint is attributable to inadequate engine power or inadequate power from the drive train (transmission). 1. Low engine power In the event of inadequate engine power, the power must be measured at the PTO via a reduction in engine speed from the rated speed to 1600 rpm, in increments of 50 rpm. Engine brakes that allow computer-assisted evaluation are recommended. These enable power and torque curves to be calculated precisely. 2.

Low drive train power (transmission) For all complaints indicating that the possible cause is transmission-related, a hydraulic measurement must be carried out in the transmission before any repairs are attempted. The "Transmission pressure measurement (fax template)" test re- port must also be filled out. The procedures in this document are repeated as a check following the repair. D ANGER : For all transmission pressure measurements, all 4 tractor wheels must be jacked up to prevent the risk of accident! I MPORTANT : Engage 4WD 919 .. 0101-1000 925 .. 1001- 934 .. 0101-1000 919 .. 1001- 928 .. 0101-1000 934 .. 1001- 922 .. 0101-1000 928 .. 1001- 922 .. 1001- 931 .. 0101-1000 925 ..

0101-1000 931 .. 1001- High-pressure check is also possible via terminal A040 or A054. 2 Measuring transmission pressure Oil temperature in the transmission 35-45°C 1005 - Overall system/transmission E - Measuring and testing 28 T000508 Version 1 22-06-2007 E - Measuring and testing