I003620 Fig. 17. I003621 Fig. 18. I003622 Fig. 19. I003623 Fig. 20. 919 .. 0101-1000 925 .. 1001- 934 .. 0101-1000 919 .. 1001- 928 .. 0101-1000 934 .. 1001- 922 .. 0101-1000 928 .. 1001- 922 .. 1001- 931 .. 0101-1000 925 .. 0101-1000 931 .. 1001- Turn the axle housing (15) round. Heat the inner ring of the taper roller bearing (27) to ap- prox. 80°C and press it on as far as it will go. Lubricate the rear axle shaft bearing with transmission oil. Support the axle housing (15) from below. There must be slight play in the rear axle shaft bearing. Attach the torque gauge X899.980.150.000 and measure and note the torque resistance of the shaft seal ring, e.g. 5.0 Nm. N OTE :
If possible, emplace the shims (26) so that the 1.0 mm thick shim (26) faces the sectioned ring (25). Place two shims, order no. X534.739.501, (thickness: 1.0 mm each) onto the rear axle shaft (31). Then attach and tighten the planetary carrier. The torque resistance of the rear axle shaft bearing must increase. N OTE : If the torque resistance does not increase, remove the planetary carrier once again and insert further shims (26) beneath the sectioned ring (25). Then pre-tension the rear axle shaft bearing once more. Select the thickness of the shims (26) so that the sec- tioned ring has no play once in place.
1015 - Transmission/axle drive G - Repair 14 T001212 Version 1 07-11-2007 G - Repair