Fendt 900 Vario COM III — 1 Dismantling and reassembling axle drive

1015 - Transmission/axle drive G - Repair I003616 Fig. 13. I003617 Fig. 14. I003618 Fig. 15. I003615 Fig. 16. 13 T001212 Version 1 07-11-2007 Withdraw the inner ring from the taper roller bearing (28) using X899.980.159.000 extraction tool. Then push the shaft seal ring (30) off. Where removed: Press the outer ring of the taper roller bearing (28) in as far as it will go. Emplace the snap ring (29) into the groove. On the opposite side, press the outer ring of the taper roller bearing in as far as it will go. Heat the inner ring of the taper roller bearing (28) to ap- prox. 80°C and place it in the axle housing (15).

Coat the outside of the shaft seal ring (30) with sealing compound X903.051.711, and the inside with a (1:1) spirit/water mixture and press it in as far as it will go. Before the inner ring cools down, insert the rear axle shaft (31) with the assembly clamps (self made, see picture) at- tached as far as it will go. 919 .. 0101-1000 925 .. 1001- 934 .. 0101-1000 919 .. 1001- 928 .. 0101-1000 934 .. 1001- 922 .. 0101-1000 928 .. 1001- 922 .. 1001- 931 .. 0101-1000 925 .. 0101-1000 931 .. 1001- Assembling axle drive Assembly: G - Repair