Fendt 900 Vario COM III — 2 Fit the continuous drive train

1080 - Transmission/drive train G - Repair I002880 Fig. 37. I002881 Fig. 38. I002882 Fig. 39. I002883 Fig. 40. 21 T000671 Version 2 04-02-2010 Check the bushes for wear and, if necessary, use new bushes Insert four bushes into bores as far as they will go N OTE : When tightening each of the nuts, hold the sec- ond nut on the shaft against it Turn one of the planet wheels of the power distribution planetary gear upwards 919 .. 0101-1000 925 .. 1001- 934 .. 0101-1000 919 .. 1001- 928 .. 0101-1000 934 .. 1001- 922 .. 0101-1000 928 .. 1001- 922 .. 1001- 931 .. 0101-1000 925 .. 0101-1000 931 ..

1001- Fit the rings to the left and right as appropriate to the shaft, with the cut-out towards the bushing Screw on the M20 nuts Using a feeler gauge, centralise the transmission unit (same play to left and right) Tighten the four M20 nuts Torque: 250 Nm Remove the hoist G - Repair