Fendt 900 Vario COM III — 4 Replacing high-pressure limiting valve

I002226 Fig. 77. I002228 Fig. 78. I002250 Fig. 79. 919 .. 0101-1000 925 .. 1001- 934 .. 0101-1000 919 .. 1001- 928 .. 0101-1000 934 .. 1001- 922 .. 0101-1000 928 .. 1001- 922 .. 1001- 931 .. 0101-1000 925 .. 0101-1000 931 .. 1001- 4 Replacing high-pressure limiting valve Preliminary work: Drain off transmission oil (approx. 87 l), unscrew the two screw plugs on the underside of the transmission. The high-pressure limiting valves are servo-assisted pres- sure limiting valves. Only replace O-rings if they are damaged, take care with the positioning of the support rings Tighten the2V3 and 2V4 to 250 + 20 Nm, tighten the plug screws to 100 Nm I MPORTANT :

If a high-pressure limiting valve (2V3 or 2V4) was dismantled for inspection, the transmission must be topped up using the external filling station! Dismantle 2V3 or 2V4 using socket spanner (SW 27) N OTE : 2V3 = high-pressure limiting valve, forwards 2V4 = high-pressure limiting valve, reverse Used pressure setting: 520 ± 20 bar 1080 - Transmission/drive train G - Repair New pressure setting: 540 bar 34 T000756 Version 1 07-11-2007 G - Repair