Fendt 900 Vario COM III — 2 Assembling and dismantling live PTO clutch and gears

1220 - Transmission / Live PTO G - Repair I003727 Fig. 79. I003716 Fig. 80. I003717 Fig. 81. I003718 Fig. 82. 37 T001262 Version 1 07-11-2007 Adjust the play on the bearing of the bell housing (3) Fit the existing shim (1) or the shim (1) on the deep- groove ball bearing (2). Measure and record the distance to the flange surface. E.g. 178.6 mm The size of the bearing contact surface with the flange surface is indicated in white colour at the top of the rear axle housing. E.g. 178.71 The size of the deep-groove ball bearing (2) washer to the flange surface of the housing cover must be smaller by 0.1 mm ... 0.2 mm than the size indicated.

This means that the bearing must have a play of 0.1 mm ... 0.2 mm . In the event of deviations, correct it using a shim (1). The size of the lower shaft from the bearing entry flange to the flange surface is given in white colour below in the rear axle housing, e.g. 148.75. N OTE : This dimension is not required for repair, since a gauge is required to measure the play in the bearing. Check the play in the bearing of the lower shaft (120): Please refer to the detailed description Place the shims (1) in the upper bore. Fit and grease four new O-rings for the pressure connec- tions. 919 .. 0101-1000 925 .. 1001- 934 .. 0101-1000 919 .. 1001- 928 .. 0101-1000 934 .. 1001- 922 ..

0101-1000 928 .. 1001- 922 .. 1001- 931 .. 0101-1000 925 .. 0101-1000 931 .. 1001- G - Repair