Fendt 900 Vario COM III — 2 Assembling and dismantling live PTO clutch and gears

I003643 Fig. 83. I003641 Fig. 84. I003719 Fig. 85. I003720 Fig. 86. 919 .. 0101-1000 925 .. 1001- 934 .. 0101-1000 919 .. 1001- 928 .. 0101-1000 934 .. 1001- 922 .. 0101-1000 928 .. 1001- 922 .. 1001- 931 .. 0101-1000 925 .. 0101-1000 931 .. 1001- Secure the housing cover in the hoist and fit the rear axle housing. Where removed: Coat the new shaft seal ring (126) externally with a thin layer of X903.051.711 sealing agent - with the lip seal fac- ing the oil chamber - press it into the bearing cover (128) until it is in place. (offset approx. 5 mm ) Put the existing shims (124) in place. Place the new O-ring (127) in the notch of the bearing cover (128) and grease it.

Coat the threads of the hex screws (129) with X 903.050.084 synthetic bonding agent and tighten them. W ARNING : Do not walk or stand under sus- pended loads! Tighten the fixing bolts and nuts M18 with 400 Nm . Adjust the play of the shaft (120) 1220 - Transmission / Live PTO G - Repair Fill sealing lips 2/3 with grease. 38 T001262 Version 1 07-11-2007 G - Repair