2000 - Overall system/engine A - General I001074 Fig. 4. Duty: The B055 - Sensor, foot throttle conveys the driver's desired torque/power to the 7).. Function: The B055 - Sensor, foot throttle consists of two potentiometers (redundant). Potentiometer 1 responds to the rotation of a shaft in the pedal position sensor when the foot throttle (throttle pedal) is depressed. The potentiometer mounted on the end of the shaft transmits an analogue voltage signal to the A050 - ECU, basic control unit. The A050 - ECU, basic control unit senses the exact throttle pedal position and hence the driver's cur- rent requirement (target value) from the voltage value.
So as to improve driving comfort, the throttle pedal position is regulated by a mapping field and further processed to damp it. The voltage signal from potentiometer 1 is responsible for engine speed control, the throttle pedal module and the Tractor Management System (TMS). The part of the sensor is powered by the tractor electronics A013 - PCB, microfuses . If this voltage signal drops out, the tractor switches to emergency mode (loss of enhanced control functions). The engine speed (target value) can then only be transmitted via the foot throttle potentiometer 2. TMS, throttle pedal mode and the memory buttons cannot be pre-selected.
When the foot throttle (throttle pedal) is depressed, potentiometer 2 responds to the rotation in exactly the same way. This analogue voltage signal is transmitted to the A051 - ECU, engine control unit (EDC 7).. The A051 - ECU, engine con- trol unit (EDC 7). senses the exact throttle pedal position and hence the driver's current requirement (target value) from the voltage values. So as to improve driving comfort, the throttle pedal position is regulated by a mapping field and further processed to damp it. Both voltage signals from the B055 - Sensor, foot throttle are compared with each other. If control units A050 - ECU, ba- sic control unit and A051 - ECU, engine control unit (EDC 7).
detect differing values to potentiometer 1 and potentiometer 2, then a plausibility error is output. 17 T002541 Version 1 04-09-2009 919 .. 0101-1000 925 .. 1001- 934 .. 0101-1000 919 .. 1001- 928 .. 0101-1000 934 .. 1001- 922 .. 0101-1000 928 .. 1001- 922 .. 1001- 931 .. 0101-1000 925 .. 0101-1000 931 .. 1001- 2 + supply (8.5 VDC) 5 + supply (5.0 VDC) 5 B055 sensor, foot throttle Pin Function 1 Earth 3 Signal 4 Earth 6 Signal N OTE : see §63 A - General Pin Function 1 Earth 2 + supply (8.5 VDC) 3 Signal 4 Earth 5 + supply (5.0 VDC) 6 Signal