Fendt 900 Vario COM III — 7 B086 rail pressure sensor

I001086 I002123 Fig. 11. Design and mode of operation of the B086 - Rail pressure sensor The core of the sensor consists of a steel membrane (3) on which expansion resistors have been vapour deposited to form a bridge circuit. As soon as the pressure to be measured via the pressure connection (4) takes effect on the steel membrane (3), the resistance value of the expansion resistors changes due to the membrane flexion. The output voltage of 0 to 80 mV generated by the bridge circuit is forwarded to an evaluation circuit (2) via a connecting cable. The evaluation circuit amplifies the signal to approx. 0.5 VDC at idling speed and approx.

4.5 VDC at maximum pressure, and forwards the signal to the A051 - ECU, engine control unit (EDC 7).. With the assistance of the Y091 dispensing unit, the A051 - ECU, engine control unit (EDC 7). controls the fuel high pres- sure in the rail (pressure accumulator) D ANGER : fuel system! The rail pressure is displayed as a target and actual value in the Deutz "SERIDA" diagnostics program. 919 .. 0101-1000 925 .. 1001- 934 .. 0101-1000 919 .. 1001- 928 .. 0101-1000 934 .. 1001- 922 .. 0101-1000 928 .. 1001- 922 .. 1001- 931 .. 0101-1000 925 .. 0101-1000 931 .. 1001- 3 Steel membrane with expansion resistors 4 Pressure connection p Rail pressure (400 to approx.

1400 bar during normal operation) 7 Pin 1 2 3 1 Separation point 2 Evaluation circuit Item Designation 5 Thread 2000 - Overall system/engine A - General 20 T002544 Version 1 04-09-2009 N OTE : see §78 A - General Pin Function 1 Earth 2 Signal 3 Supply Item Designation 1 Separation point 2 Evaluation circuit 3 Steel membrane with expansion resistors 4 Pressure connection 5 Thread p Rail pressure (400 to approx. 1400 bar during normal operation)