Fendt 900 Vario COM III — 5 Y091 dispensing unit (fuel)

Check Chassis Range! 2060 - Engine/fuel system A - General I006258 Fig. 10. The - Dispensing unit (fuel), which is governed by the engine control unit according to the engine load and speed, supplies the amount of fuel that is fed to the high pressure pumps. In this way the systems determines the pressure in the rail. If the dispensing unit is not activated, spring (11) pushes piston (10) upwards. The flow from the delivery pump to the high-pressure pumps is opened to the maximum and a large quantity of fuel is fed to the high-pressure pumps. The solenoid coil of the dispensing unit is activated by a pulse width modulated signal from the engine control unit.

De- pending on the degree of actuation, piston (10) alters the flow to the high-pressure pumps. The following rule applies: The higher the degree of activation, the less the quantity of fuel that is fed. The quantity of fuel that is not fed to the high-pressure pumps flows via the overflow valve back into the tank. The engine control unit governs the rail pressure via the Y091 - Dispensing unit (fuel) in conjunction with the B086 - Rail pressure sensor. The dispensing unit is the actuator for the high-pressure control circuit. 17 T002074 Version 1 20-10-2009 To the high-pressure pumps 5 Zero-delivery choke Designation Item Designation Dispensing unit 3 Return flow 4 Overflow valve Fuel flow:

Dispensing unit Item Designation Item Designation Y091 Dispensing unit 3 Return flow 1 Feed 4 Overflow valve 2 To the high-pressure pumps 5 Zero-delivery choke