I001585 Fig. 7. I001584 Fig. 8. I007578 Fig. 9. 919 .. 0101-1000 925 .. 1001- 934 .. 0101-1000 919 .. 1001- 928 .. 0101-1000 934 .. 1001- 922 .. 0101-1000 928 .. 1001- 922 .. 1001- 931 .. 0101-1000 925 .. 0101-1000 931 .. 1001- If necessary, bleed the low pressure circuit: vent plug (A) Unscrew Prime with the hand pump until fuel is discharged without any air bubbles. Close vent plug (A). Pump the hand pump (A) until strong resistance is felt, then continue pumping for a few more strokes. Start the engine, allow to warm up for max. 30 seconds. N OTE : Air in the high-pressure system may result in un- acceptable pressure fluctuations in the common rail sys- tem.
Therefore, the tractor should be operated under low load for about 5 minutes. Open bleed screw (A) for the fuel pre-filter. Keep pumping with manual delivery pump (B) until strong resistance is felt; pump on for a few strokes after this. Close the bleed screw for the fuel pre-filter. Start engine. N OTE : Air in the high-pressure system may result in un- acceptable pressure fluctuations in the common rail sys- tem. Therefore, the tractor should be operated under low load for about 5 minutes. A Vent plug B Water drain plug C Filter cap 2060 - Engine/fuel system G - Repair 42 T001181 Version 2 21-04-2009 Version II G - Repair