Fendt 900 Vario COM III — 3 Removing and installing the high-pressure limiting valve and rail pressure sensor

2060 - Engine/fuel system G - Repair I001562 Fig. 10. I001564 Fig. 11. I001565 Fig. 12. 43 T002829 Version 1 04-09-2009 D ANGER : After switching off the diesel engine, wait at least 30 seconds before starting any work on the fuel system! W ARNING : Ensure the utmost cleanliness! See Service Information 14/2007. 3 Removing and installing the high-pressure limiting valve and rail Removing and fitting the high-pressure limiting valve The high-pressure limiting valve limits the maximum per- mitted fuel high pressure in the rail (pressure accumula- tor) to approx. 1800 bar N OTE : After the high-pressure limiting valve has been ac- tuated approx. 30 times, it should be replaced.

In case of leaks in the high-pressure limiting valve, the fuel is heated. The B086 - Rail pressure sensor and the high-pressure limiting valve must always be replaced at the same time! 919 .. 0101-1000 925 .. 1001- 934 .. 0101-1000 919 .. 1001- 928 .. 0101-1000 934 .. 1001- 922 .. 0101-1000 928 .. 1001- 922 .. 1001- 931 .. 0101-1000 925 .. 0101-1000 931 .. 1001- Unscrew and remove the high-pressure limiting valve from the rail. Check thread and sealing lip for damage (arrowed). pressure sensor N OTE : Collect any escaping fuel. G - Repair