MH6.6 / MH8.6 CALIBRATION 6-5 After corresponding selection and confirmation with the SET key, the display shows the message "CALIBRATION ON GOING". (Fig. 2). After the calibration, "CALIBRATION DONE" (Fig. 3) is displayed on the screen. The displayed number is a service information. ON GOING Fig. 2 Fig. 3 The displayed number (Fig. 2) is a progress counter. The time needed for calibration in individ- ual menu points differs and can be as long as sev- eral minutes. The progress counter informs you about the current state of the calibration proce- dure. After pressing the SET key = Exit, the program returns to the next higher menu.
Further calibra- tion categories can then be selected and exe- cuted. To get back to the next higher menu, press the arrow UP [ ] or the arrow DOWN [ ] key until the start or the end of the display selection is reached. In the course of calibration you are requested by display messages in the different menus to hold specific control levers and pedals in maxi- mum position. If you change the position of these control levers or pedals before being requested to do so, the calibration procedure is abor- ted. In this case, a corresponding message is displayed. The switches, pushbuttons and control elements to be activated for this purpose are indicated by their item number.
Further details can be found in the sections "Switches / pushbuttons" and "Control elements" of the Operator's Manual. Carefully read personal and machine SAFETY INSTRUCTIONS (at the beginning of this manual)