Cummins — 4021389

Troubleshooting Symptoms Charts B3.9, B4.5, B5.9 Industrial Page TS-30 Section TS - Troubleshooting Symptoms Engine Runs Rough at Idle Cause Correction Allow the engine to warm to operating temperature. If the engine will not reach operating temperature, refer to the Coolant Temperature Below Normal symptom tree. STEP 1 Engine is cold ............. OK Go To Next Step STEP 2 Idle speed is set too low for accessories ............. Check and adjust the low-idle screw. Refer to a Cummins® Authorized Repair Location. OK Go To Next Step STEP 3 Air in the fuel system ............. Check for air in the fuel system.

Tighten or replace the fuel connections, fuel lines, fuel tank standpipe and fuel filters as necessary. Vent air from the system. Refer to a Cummins® Authorized Repair Location. OK Go To Next Step Measure the fuel pressure before and after the fuel filter. Refer to a Cummins® Authorized Repair Location. STEP 4 Fuel filter is plugged ............. OK Go To Next Step STEP 5 Fuel supply is not adequate ............. Check the flow through the filter to locate the source of the restriction. Refer to a Cummins® Authorized Repair Location. OK Go To Next Step STEP 6 Fuel lift pump is malfunctioning ............. Check the fuel lift pump for correct operation. Check the pump output pressure.

Replace the fuel lift pump if necessary. Refer to a Cummins® Authorized Repair Location. OK Go To Next Step STEP 7 Engine mounts are worn, damaged, or not correct ............. Check the engine mounts. Refer to the OEM service manual. OK Go To Next Step Operate the engine from a tank of high-quality fuel. Refer to Procedure 018-002 (Fuel Recommendations and Specifications) in Section V. STEP 8 Fuel grade is not correct for the application or the ............. fuel quality is poor OK Go To Next Step STEP 9 Contact a Cummins® Authorized Repair Facility