B3.9, B4.5, B5.9 Industrial Drive Belts Section 3 - Maintenance Procedures at Daily Interval Page 3-5 Drive Belts Maintenance Check Poly-Vee Belt CAUTION Make sure that the engine is switched off and any starting mechanisms are isolated before any inspections are made. Daily belt inspections can be carried out through an appropriate aperture. Do not remove any guards. Inspect the belts daily. Check the belt for intersecting cracks. Traverse (across the belt width) cracks are acceptable. Longitudinal (direction of belt length) cracks that intersect with transverse cracks are not acceptable. Replace the belt if it is frayed or has pieces of material missing.
Refer to Section A for belt adjustment and replacement procedures. Belt damage can be caused by: Incorrect tension Incorrect size or length Pulley misalignment Incorrect installation Severe operating environment Oil or grease on the side of belts. Cogged Belt Inspect the belts daily. Replace the belts if they are cracked, frayed, or have chunks of material missing. Small cracks are acceptable. Adjust the belts that have a glazed or shiny surface, which indicates belt slippage. Correctly installed and tensioned belts will show even pulley and belt wear. Refer to Section A for belt adjustment and replacement procedures. Belt damage can be caused by:
Incorrect tension Incorrect size or length Pulley misalignment Incorrect installation Severe operating environment Oil or grease on the belts