Fuel-Water Separator B3.9, B4.5, B5.9 Industrial Page 3-6 Section 3 - Maintenance Procedures at Daily Interval Measure the belt tension in the center span of the pulleys. Refer to the Belt Tension Chart in Section V for the correct gauge and tension value for the belt width used. An alternate method (deflection method) can be used to check belt tension by applying 110 N [25 lbf] force between the pulleys on v-belts. If the deflection is more than one belt thickness per foot of pulley center distance, the belt tension must be adjusted. Refer to Section A for adjustment procedures.
For cogged belts, make sure that the belt tension gauge is positioned so that the center tensioning leg is placed directly over the high point (hump) of a cog. Other positioning will result in incorrect measurement. Fuel-Water Separator Drain WARNING Drain the water-fuel separator into a container and dispose of in accordance with local environmental regulations. Cummins Inc. requires a fuel-water separator or fuel filter be installed in the fuel supply system. Drain the water and sediment from the separator daily. Canister Type Shut off the engine. Pull up on the drain valve lever until fluid drains out of the drain tube. Drain the filter sump until clear fuel is visible.
Push up on the drain valve until fluid drains out of the drain tube.