Cummins — 4021389

B3.9, B4.5, B5.9 Industrial Fuel Filter (Canister Type) Section 5 - Maintenance Procedures at 500 Hours or 6 Months Page 5-1 Maintenance Procedures - Overview General Information All maintenance checks and inspections listed in previous maintenance intervals must also be performed at this time, in addition to those listed under this maintenance interval. Engine Coolant Antifreeze Maintenance Check CAUTION Overconcentration of antifreeze or use of high silicate antifreeze can cause damage to the engine. Check the antifreeze concentration. Use a mixture of 50- percent water and 50-percent ethylene glycol or propylene glycol-base antifreeze to protect the engine to -32°C [-25°F] year-around.

The Fleetguard® refractometer, Part Number C2800, provides a reliable, easy to read, and accurate measurement of freezing point protection and glycol (antifreeze) concentration. Antifreeze is essential in every climate. It broadens the operating temperature by lowering the coolant freezing point and by raising its boiling point. The corrosion inhibitors also protect the cooling system components from corrosion and provides longer component life. Fuel Filter (Canister Type) Preparatory Steps Drain the fuel-water separator into a container, and dispose of contents in accordance with local environmental regulations.

WARNING Lift up on the filter drain lever to drain fuel out of the filter for approximately 5 seconds. This will eliminate fuel from running over the top of the filter upon removal.