Fuel Filter (Canister Type) B3.9, B4.5, B5.9 Industrial Page 5-2 Section 5 - Maintenance Procedures at 500 Hours or 6 Months Remove Remove the filter lid and filter element. A crescent wrench can be used if the lid can not be removed by hand. NOTE: Remove the filter element by twisting the element sideways from the filter lid. Clean all debris from around the canister lid. Install Install the new element in the canister lid, and place back in the canister by twisting clockwise . Refer to Procedure 018-024 (Cummins/Fleetguard® Filter Specifications) in Section V. NOTE: The replacement filter element comes with a new o-ring for the canister lid.
The o-ring must be replaced with the filter element. Lubricate the o-ring with clean engine oil. Hand-tighten the canister lid. Prime Controlled venting is provided at the injection pump through the fuel drain manifold. Small amounts of air introduced by changing the filters or injection pump supply line will be vented automatically if the fuel filter is changed in accordance with the instructions. However, manual bleeding will be required if one of the following conditions exists:
The fuel filter is not filled prior to installation The fuel injection pump is replaced The high-pressure fuel line connections are loosened or the lines are replaced It is an initial engine start-up or start-up after an extended period of no engine operation.