Run the engine for a short time, during running check and ensure no leakage from the filter sealing and from the oil drain plug refer figure 5.7 OK Figure 5.7 Stop the engine; check the tightness of filter for reliability, if necessary. Measure the oil level with the help of the oil dipstick. To get correct oil level, always check it 5 to 10 minutes after stopping the engine 5.7.5 Cleaning of oil gas separator Oil gas separator is functioning as a ventilator for crank case to release the flugases by controlling the oil wastage/ consumption/ spillage. Periodic maintenance and monitoring will help us to understand the health of combusting system.
5.7.6 Replacement of fuel filter Use the filter wrench to loosen the filter and remove it by hand. Use a suitable tray under the filter location to collect diesel spillage before removing the filter. Loosen and remove the filter. Refer figure 5.8 & 5.9. Figure 5.8 Figure 5.9 Let the fuel drain completely from the filter housing. Wipe the sealing surface with a clean cloth, and apply fresh oil to the seal ring, then tighten new diesel filter with the filter wrench 32