5.7.7 Air bleeding from fuel system After every filter change and maintenance of engine fuel system, or air entered into the system, check the whole fuel system and bleed out the air from the system. (Refer figure for 5.10 & 5.11 for main air bleeding points in the fuel system) Figure 5.10 Figure 5.11 5.7.8 Adjustments and replacement of V-Belt Two B type V belts used to drive the fresh water pump and the charging alternator. Refer Fig. 5.12 Check the belt tension regularly; do neccessary adjustments if required. If the belt tension is incorrect, it will lead to various troubles like high water, poor charging of battery etc.
While checking, if the belt is flexible by more than 10 mm (When applying a strong force by thumb - refer Fig. 5.13) the belt needs adjustment. The belt tension can be adjusted from the alternator mounting support (refer Fig. 5.14) Replace the belt(s) if any damage (peel off, crack, rib crank or wear etc.) is noticed. Refer periodic maintenance for belt replacement interval. Figure 5.12 Figure 5.13 Figure 5.14 33