8 MOVING ELEMENT 7 CONROD BIG END BEARING I R 8 CONROD I I 9 CRANK CASE - CAM SHAFT - CRANK SHAFT - GEAR TRAIN 1 MAIN BEARINGS & THRUST BEARINGS R 2 CAM BUSH BEARING R 3 BEARINGS RELATED TO GEAR TRAIN R 4 OIL SEALS R R 5 TAPPET I I 6 CAM SHAFT I 7 CRANK SAHFT I 8 CAM & IDLE GEAR I 9 ROLLER BEARING R 10 FASTNERS I 10 OTHERS SUB ASSEMBLIES 1 FAN BELT M M R R R R 2 BELT TENSIONOR PULLEY R R 3 FLEXIBLE HOSES AND CLAMP C C C C C R R 4 SET OF O RINGS AND GASKETS REPLACE EVERY TIME WHEN REMOVED 5 STARTER MOTOR M M M M I&S I&S 6 ALTERNATOR M M M M I&S I&S 7 DISPLAY MONITOR M M M M I&S I&S 8 WIRE HARNESS M M M M I&S I&S 9 FUEL SHUT OFF SOLINOID M M M M I&S I&S 10 ENGINE STOP SOLINOID M M M M I&S I&S 11 VIBRATION DAMPER M M M M I&S I&S 12 GAS OIL SEPARATOR C C C I&S Table 5.2 Replacement period of engine oil varies according to the operating conditions as below.
Normal operating condition (the above-listed is normal operation condition, when the oil consumption is normal): the ambient temperature is normal, and fuel with sulfur content lower than 0.5% (by weight) is used. Adverse operating condition (oil consumption is high): 1. In tropical climate or cold zone (temperature exceeds +30° or lower than -10°), the oil drain period shall be half of that un der normal operation condition. 2. When sulfur content of fuel with is 0.5~1.5%, the oil drain period shall be half of that under normal operation condition. 3. In adverse operating condition with A+B, the oil drain period shall be one fourth of that under normal operation condition. 39 39