128 RT115 Tier 2 - SAW ATTACHMENT OPERATION 8. Following procedures in "Operation," begin sawing to desired depth. 9. When desired depth is reached, ensure throttle is fully open. 11. Slowly adjust cruise control rpm control to match digging conditions. In harder digging conditions, higher cruise control rpm setting may improve digging performance. In easier digging conditions, lower cruise control rpm setting may increase ground drive speed. See "Operating Tips." 12. When finished digging, move ground drive control to neutral. EMERGENCY SHUTDOWN - Turn ignition switch to STOP. 10. Slowly move ground drive control to full forward position. 6.
Move cruise control RPM control to arrow at center. 14. Allow saw to dig itself free before stopping attachment. 4. Ensure cruise control selector is in MANUAL. 5. Ensure that all controls are set as desired. 13. Move cruise control selector to MANUAL. 1. Ensure ground drive control is in neutral. 2. Ensure hydraulic motor switch is in low. 7. Move cruise control selector to AUTO. 3. Ensure gearbox control is in 1 (low). Cruise Control Operation p