Miscellaneous—Machine Replacing Alternator Belt 1. Inspect belt for cracks, fraying, or stretched out areas. Replace if necessary. 2. To replace belt, release tension on belt. 3. Remove belt from pulleys, and discard belt. TX1066463 —UN—19OCT09 4. Install new belt, making sure belt is correctly seated in all pulley grooves. 5. Start engine, and check belt alignment. With Air Conditioner TX1066464 —UN—19OCT09 Without Air Conditioner OUT4001,00004F1 -19-03NOV09-1/1 Adjusting Boom and Bucket Linkage—Hands Only Machines If boom and bucket cycle times are slow, adjust boom and bucket linkage. 1. Raise boom and lock in raised position. TX1066107A —UN—15OCT09 2. Park machine and shut OFF engine. 3.
Turn key to RUN position. 4. Press park brake switch to middle position to actuate hydraulics while park brake is engaged. 5. Pivot each control lever left and right. Ensure that boom control valve locks into detent. 6. Confirm that when control levers are returned to neutral position, they are in the center of opening range. 1— Nut (2 used) 7. Raise and lock operator's station in up position. 10. Install footwell and lower operator's station. 8. Remove footwell. 9. If necessary, adjust positions of cables forward or backward using nuts (1) to properly position control levers. 11. Lower boom to the ground. OUT4001,00004F2 -19-05NOV09-1/1 4-1-10 071713 PN=141