Miscellaneous—Machine Adjusting Pedal Angle—Hand and Foot Machines The angle of the pedals can be adjusted to suit different operators or different footwear. TX1066428A —UN—16OCT09 Adjust the angle by increasing or decreasing the length of the rods (1). Increasing length of the rod, increases pedal angle. Decreasing length of the rod, decreases pedal angle. 1. Remove footwell. 2. Loosen nuts (2). 3. Turn the rod to desired length until pedal is at comfortable angle. Make sure there is still thread engagement. 1— Rod (2 used) 2— Nut (4 used) 4. Tighten nuts. 5. Install footwell. OUT4001,00004F3 -19-05NOV09-1/1 Replacing Fuses 1. Fuses are located in operator's station on the right side. 2.
Remove fuse panel cover (1). 3. Pull off protective cap. 4. Pull fuse out of socket. 5. Check metal clip in fuse window. Discard fuse if clip is broken. 6. Push new fuse into proper socket. Be sure new fuse is the same amperage as removed fuse. 1— Fuse Panel Cover TX1066401A —UN—16OCT09 Fuse Panel Cover Continued on next page OUT4001,00004F5 -19-03DEC12-1/2 4-1-11 071713 PN=142