Miscellaneous—Operational Checkout 6 Back-Up Alarm Check (If Equipped) CAUTION: Prevent injury from unexpected machine movement. Keep bystanders clear of machine. Engine speed at slow idle. YES: Go to next check. Drive machine in reverse. NO: Check accessory 20 amp fuse (F7) and key switch unswitched power 7.5 amp fuse (F1). LOOK/LISTEN: Does back-up alarm sound? NO: See your authorized dealer. 7 Steering Mistracking Check OUT4001,000051E -19-04DEC09-17/28 CAUTION: Prevent injury from unexpected machine movement. Keep bystanders clear of machine. Engine speed at fast idle. Drive machine at full speed forward on a flat and level surface for 30 m (100 ft.).
Repeat procedure for reverse direction. Observe which direction and how much the machine mistracks from a straight line. YES: See your authorized dealer. LOOK: Does machine mistrack more than the width of the machine over 30 m (100 ft.)? NO: Go to next check. 8 Boom Down Drift Check NOTE: This check may require two people. OUT4001,000051E -19-04DEC09-18/28 NOTE: Machine must be equipped with a bucket for this check. Close cab door—if equipped. Specification Hydraulic Oil—Temperature..................................................................................... 43°C 110°F Operate hydraulic system until hydraulic oil reaches temperature specification.
Actuate boom function to lower boom to ground. Raise boom halfway. Engage park brake. Mark and record a distance on the boom cylinder rod from the cylinder barrel. Disengage park brake. Allow machine to sit with engine speed at slow idle for 5 minutes. Engage park brake. Measure marked distance on boom cylinder rod. NO: Go to next step in this check. Specification Boom Cylinder—Drift (maximum)........................................................... 12.7 mm/5 min. 0.5 in./5 min. LOOK: Does boom drift down more than specification? YES: Go to next check. Raise boom halfway. Engage park brake. Turn engine off. Allow machine to sit for 5 minutes. YES: See your authorized dealer.
Specification Boom Cylinder—Drift (maximum)........................................................... 12.7 mm/5 min. 0.5 in./5 min. LOOK: Does boom drift down more than specification? NO: Go to next check. Continued on next page OUT4001,000051E -19-04DEC09-19/28 4-2-5 071713 PN=150