John Deere 326D, 328D, 332D — Key Switch ON, Engine ON Checks

Miscellaneous—Operational Checkout 11 Bucket Curl Drift Check NOTE: This check may require two people. NOTE: Machine must be equipped with a bucket for this check. Close cab door—if equipped. Operate hydraulic system until hydraulic oil reaches temperature specification. Specification Hydraulic Oil—Temperature..................................................................................... 43°C 110°F Dump bucket halfway. Actuate boom down function to raise front of machine off the ground. Engage park brake. Mark and record a distance on the bucket cylinder rod from the cylinder barrel. Disengage park brake. Allow machine to sit with engine speed at slow idle for 5 minutes.

Engage park brake. Measure marked distance on bucket cylinder rod. NO: Go to next step in this check. Specification Bucket Circuit—Drift (maximum)............................................................. 12.7 mm/5 min. 0.5 in./5 min. LOOK: Does bucket drift up more than specification? YES: Go to next check. Dump bucket halfway. Actuate boom down function to raise front of machine off the ground. Engage park brake. Turn engine off. Allow machine to sit for 5 minutes. Specification Bucket Cylinder—Drift (maximum).......................................................... 12.7 mm/5 min. 0.5 in./5 min. YES: See your authorized dealer. LOOK: Does bucket drift up more than specification? NO:

Go to next check. 12 Auxiliary Hydraulic Override Check OUT4001,000051E -19-04DEC09-22/28 CAUTION: Prevent injury from operating attachments. Stay clear of moving parts on the attachment. Close cab door—if equipped. Operate auxiliary hydraulic function. Raise interlocking seat bar and exit machine. LISTEN/LOOK: Do the auxiliary hydraulics shut off? Return to seat, lower interlocking seat bar and close cab door—if equipped. Operate auxiliary hydraulic function. Press auxiliary hydraulic override switch. LOOK: Does “AUX HYDRAULIC BYPASS” appear in EMU display? NOTE: Operator must exit machine within 15 seconds of pressing auxiliary hydraulic override switch. Open cab door and exit machine.

LISTEN/LOOK: Do the auxiliary hydraulics continue to operate after operator has exited the machine? Return to seat, lower interlocking seat bar and close cab door, if equipped. Disengage auxiliary hydraulics. YES: Go to next check. LOOK: Does EMU exit “AUX HYDRAULIC BYPASS” mode and return to last run data item? NO: See your authorized dealer. Continued on next page OUT4001,000051E -19-04DEC09-23/28 4-2-8 071713 PN=153