Operation—Operator’s Station 2. Press the NEXT button until “Main Menu AntiTheft” displays. Changing System Security Code Length Use this procedure to select the length of security code to use with the anti-theft security system, either 3-digit or 5-digit. The system default is 3-digit. 3. Press the SELECT button to display “AntiTheft Change Codes”. 4. Press the SELECT button. Display shows “Change Codes Operator 1 Code”. 1. Press the MENU button on the EMU to access the Main Menu. 5. Press the NEXT button until “Change Codes Reset All Codes” displays. 2. Press the NEXT button until “Main Menu Antitheft” displays. 6. Press the SELECT button.
Display shows “Enter Owner Code 0 _ _ ” (3-digit system) or “Enter Owner Code 0 _ _ _ _ (5-digit system). 3. Press the SELECT button to display “AntiTheft Change Codes”. 4. Press the NEXT button until “AntiTheft Number of Digits” displays. 7. Enter the current Owner security code. a. Press the NEXT button or the BACK button to change the number displayed in the active (flashing) field. The NEXT button increments the current digit; the BACK button decrements the current digit. 5. Press the SELECT button. Display shows “Enter Owner Code 0 _ _ ” (3-digit system) or “Enter Owner Code 0 _ _ _ _ (5-digit system). 6. Enter the current Owner security code. b.
Press the SELECT button to accept the number displayed (flashing) in the active field and shift the active field to the next digit to the right. a. Press the NEXT button or the BACK button to change the number displayed in the active (flashing) field. The NEXT button increments the current digit; the BACK button decrements the current digit. NOTE: Pressing the SELECT button to accept the last digit (third digit or fifth digit depending on system configuration) processes the entered security code. If the code is incorrect, an error message appears on the monitor display. b.
Press the SELECT button to accept the number displayed (flashing) in the active field and shift the active field to the next digit to the right. The anti-theft security system allows three attempts to enter a valid security code before requiring the key switch to be turned OFF and ON to restart the process. NOTE: Pressing the SELECT button to accept the last digit (third digit or fifth digit depending on system configuration) processes the entered security code. If the code is incorrect, an error message appears on the monitor display. 8.
The anti-theft security system resets the Owner and three Operator security codes to their defaults of “111”, “000”, “999”, and “998”, respectively, for 3-digit security systems, and “00111”, “00000”, “00999”, and “00998” for 5-digit security systems. The anti-theft security system allows three attempts to enter a valid security code before requiring the key switch to be turned OFF and ON to restart the process. 9. The default codes display before the EMU returns to the normal display mode menu. 7.
The current Antitheft System will be displayed, either “Select to Enable 3-Digit Codes” or “Select to Enable 5-Digit Codes.” To change the selection, press the NEXT button to cycle between the different systems and then press the SELECT button to activate. At this point, all codes will be set to anti-theft system defaults, but the system locking method will remain unchanged. NOTE: If the owner code is not available, security codes can be reset using the Master security code, which a John Deere dealer can obtain through DealerNet. Complete the anti-theft security system enable procedure to reset security codes using the Master security code. OUT4001,0000504 -19-25MAR10-3/3 2-1-10 071713 PN=41