John Deere 326D, 328D, 332D — Fire Extinguisher Location

Operation—Operator’s Station Top Window Top window (1) is standard on cab or canopy. Top window in cab is bolted in place and can be removed for cleaning. To remove top window: Remove four knobs (2) from inside the cab. Lift off window from outside the cab. Store window and hardware in a protected area. TX1066928A —UN—28OCT09 Top window in canopy is permanently installed. 1— Top Window 2— Knob (4 used) Top Window OUT4001,0000514 -19-31OCT12-1/1 Rear Window (Secondary Exit) Push on bottom corner (1) of window near the instruction label to force window out from molding. 1— Bottom Corner TX1066770A —UN—23OCT09 Secondary Exit OUT4001,0000513 -19-31OCT12-1/1 Fire Extinguisher Location NOTE:

All fire extinguishers do not operate the same. Read operating instructions on canister. The portable fire extinguisher is used to aid in the extinguishing of small fires. Refer to individual manufacturers' instructions and proper fire fighting procedures before the need to use the fire extinguisher arises. For fire prevention safety rules, see Prevent Fires. (Section 1-2.) TX1082854A —UN—11OCT10 IMPORTANT: Avoid possible machine damage. Replace or recharge fire extinguisher after every use according to the manufacturer’s instructions. Fire Extinguisher Location The designated fire extinguisher location (1) is inside the cab on either side of the rear window.

Check gauge (if equipped) on fire extinguisher. If fire extinguisher is not fully charged, recharge or replace it according to the manufacturer’s instructions. 1— Fire Extinguisher Location Inspect and maintain the fire extinguisher following the manufacturer’s recommendations and all local, regional, and national regulations. ER79617,0000C6B -19-27MAR13-1/1 2-1-17 071713 PN=48