John Deere 326D, 328D, 332D — Opening Side Windows—If Equipped

Operation—Operator’s Station 8. From inside the cab with door closed and latched, adjust the door sensor bracket (15) so there is approximately 2 mm of space between the bracket and sensor (16). Less space is allowable, but the bracket should not touch the sensor. Fully tighten the bracket nuts when adjustment is complete. TX1074098A —UN—16MAR10 15— Door Sensor Bracket 16— Sensor Door Sensor Bracket and Sensor OUT4001,000050E -19-25MAR10-4/4 Opening Side Windows—If Equipped To open side window, squeeze latch (1) and slide window rearward. To close side window, slide window forward until latch clicks into place. TX1066940A —UN—28OCT09 To remove side windows: 1. Remove cap screws (2). 2.

Remove glass retainer (3). 3. Slide back window section (4) forward to center of frame. Lift and pull bottom edge out towards operator. Remove back window section and place in a safe area. 4. Slide front window section (5) back to center of frame. Lift and pull bottom edge out towards operator. Remove front window section. 5. Store both sections in a protected area. TX1066947A —UN—28OCT09 To install side windows: 1. Install front window section first, lining up groove on bottom of window with the track in frame. Slide forward into stationary position. 2. Install back window section, lining up groove on bottom of window with the inner track in frame. Slide rearward into stationary position.

1— Latch 2— Cap Screw (2 used) 3— Glass Retainer 4— Back Window Section 5— Front Window Section 3. Install glass retainer. 4. Install cap screws. OUT4001,000050F -19-05NOV09-1/1 2-1-16 071713 PN=47