John Deere 326D, 328D, 332D — Cab Door—If Equipped

Operation—Operator’s Station Door Adjustment TX1074040A —UN—16MAR10 TX1074094A —UN—16MAR10 Striker Bolt Hinge Fasteners If door needs to be adjusted to seal properly, proceed with the following steps: 1. Position the striker bolt (11) toward the front, bottom of the mounting hole, and lightly tighten the nut. More adjustment may be required later. 2. Loosen the three hinge fasteners (12). Cycle the door open and close several times. NOTE: The top hinge holes are slotted so door can move slightly to get the proper fit. 3. Slide the upper part of hinge (13) to the left or right so there is approximately 3 mm (1/8 in) gap between striker bolt and upper jaw of latch (14).

TX1074095A —UN—16MAR10 4. Lightly tighten the three hinge fasteners. 5. Latch door and verify that there is approximately 1 mm (1/32—1/16 in) of compression on door seal near the upper, latch-side corner of the door. If there is too much compression and door latches with difficulty (door will be harder to close when the side windows are closed), adjust the striker forward. If there is not enough compression, adjust the striker rearward. Try to keep the striker at a constant height to avoid needing to readjust the hinge to maintain striker-latch jaw clearance. Upper Part of Hinge 6.

After a positive seal is achieved and the effort to close the door is acceptable, verify that the striker bolt/latch jaw clearance is still good. If not, readjust the hinge and/or striker bolt to correct the position of the striker bolt in the latch jaw. TX1074096A —UN—16MAR10 7. Once all adjustments are complete, fully tighten the striker bolt and the three hinge fasteners. Door Latch Striker Bolt 12— Hinge Fastener (3 used) 13— Upper Part of Hinge 14— Upper Jaw of Latch Continued on next page OUT4001,000050E -19-25MAR10-3/4 2-1-15 071713 PN=46