John Deere 326D, 328D, 332D — Cab Door—If Equipped

Operation—Operator’s Station Removing and Installing Door IMPORTANT: Handle door safely. When removing door, be aware that it is breakable. To remove the door: TX1066868A —UN—12NOV09 1. Park machine. 2. Raise boom and lock in raised position. 3. Engage park brake and turn engine OFF. 4. Remove the wire retainer (4) on gas shock rod (5) by rotating the wire retainer off of the shaft and pulling out. Remove gas shock rod from ball joint. Install wire retainer into shaft for storage. View Shown From Inside the Cab 5. Disconnect wiper motor harness connector (6). 6. Disconnect washer fluid line (7). Make sure to leave the check valve (8) connected to the fluid line inside the cab.

TX1067684A —UN—12NOV09 7. On outside of machine, remove cotter pin (9) and washer from top hinge pin. Store appropriately. 8. Open door until the stop (10) hits on door frame. 9. Using handles on inside of the door, carefully lift the door until the stop clears the door frame. Specification Door—Weight.................................................................................. 22 kg 48 lb 10. Door can then be rotated further until the hinge and handhold do not contact. 11. Carefully lift door the rest of the way off and store in a protected area. To install the door: 1. Park machine. 2. Raise boom and lock in raised position. TX1066919A —UN—12NOV09 3.

Engage park brake and turn engine OFF. 4. Carefully lift door. Start by having the door in the 180° open position from the front of the machine. Line up hinges with hinge pins and partially install. Slowly rotate door 90°, making sure to stay clear of handhold. Fully slide hinges down onto hinge pins. 5. Install cotter pin (9) and washer. IMPORTANT: Wiper assembly must be connected so machine knows that a door is present. If the wiper assembly is not connected when a door is present, machine will allow the boom to function with the door in the open position which may result in damage to the door.

4— Wire Retainer 5— Gas Shock Rod 6— Wiper Motor Harness Connector 7— Washer Fluid Line 8— Check Valve 9— Cotter Pin 10— Stop 6. Connect washer fluid line (7) and wiper motor harness connector (6). 8. Install gas shock rod on ball joint. Install wire retainer. 9. Verify door seals and closes properly. If adjustment is needed, see following Door Adjustment story. 7. Remove wire retainer (4) from gas shock rod (5). Continued on next page OUT4001,000050E -19-25MAR10-2/4 2-1-14 071713 PN=45