Operation—Operating the Machine Engine Break-In Period IMPORTANT: DO NOT operate engine when oil level is below ADD mark on dipstick. Check oil level before starting engine for the first time. See Check Engine Oil Level. (Section 3-4.) NOTE: The use of break-in oils is not required for this engine. Perform the following steps to break-in your engine properly during the first 250 hours. Before starting, fill engine with seasonal viscosity grade oil and coolant meeting specifications. See Diesel Engine Oil and Light Duty Diesel Engine Coolant. (Section 3-1.) 3. Watch oil pressure and coolant temperature closely during break-in period.
Also check coolant level daily or every 10 hours and check for leaks. 1. During the first 20 hours, avoid prolonged periods of engine idling or sustained maximum load operation. Warm-up engine carefully and operate at normal loads. If engine will idle longer than 5 minutes, stop engine. 4. Check alternator belt for proper alignment and seating in pulley grooves. 5. Change oil and oil filter after first 250 hours. Fill crankcase with seasonal viscosity grade oil. See Diesel Engine Oil (Section 3-1.) and Change Engine Oil and Replace Filter. (Section 3-6.) 2. Check oil level daily or every 10 hours during engine break-in period.
If oil must be added during this period, use John Deere Plus-50™II oil. See Diesel Engine Oil. (Section 3-1.) Plus-50 is a trademark of Deere & Company. OUT4001,0000522 -19-14JUL10-1/1 Starting the Engine 1. Fasten seat belt. 2. Lower interlocking seat bar. 3. Be sure all drive and auxiliary hydraulic controls are in neutral. TX1067021A —UN—29OCT09 4. Engage park brake. NOTE: The engine control unit (ECU) will default engine speed to slow idle on engine startup regardless of engine speed control dial position. Move engine speed control dial to slow idle position and then increase the setting to the desired speed to get the engine speed to increase. 1— Engine Speed Control Dial 5.
Turn engine speed control dial (1) forward to 1/3 position. 6. Turn key switch to RUN position, but do not crank engine. 9. Release key when engine starts. a. A warning light bulb check is performed each time machine is started. 7. Check engagement and monitor unit (EMU). Engine low oil pressure indicator will be lit until engine starts. IMPORTANT: To prevent damage of hydraulics and engine in temperatures below 0°C (32°F), run engine at slow idle for 10 minutes before operating controls. IMPORTANT: Avoid possible machine damage. Do not crank starter continuously for more than 45 seconds or you may damage starter. Do not use ether or any other type of starting fluid on engines. b.
Always allow engine to warm up before applying a load. Do not tow the machine to start it. Damage to hydrostatic system will occur. 10. Run at 1/3 speed for 30 seconds. Do not run at fast or slow idle. Do not accelerate rapidly during warm-up. 11. Operate machine at less-than-normal loads and speeds until engine is at normal operating temperature. 8. Turn key switch to START position. NOTE: If engine does not start within 45 seconds, turn key switch to OFF position and allow starter to cool for 1 minute before trying again. OUT4001,0000521 -19-25JUL11-1/1 2-2-3 071713 PN=55