John Deere 326D, 328D, 332D — Engine Block Heater—If Equipped

Operation—Operating the Machine Cold Weather Starting NOTE: It is normal for battery voltage indicator to light when glow plugs are active. IMPORTANT: To prevent damage to hydraulics and engine in temperatures below 0°C (32°F), run engine at slow idle for 10 minutes before operating controls. NOTE: Recommended oils for improved starting performance, see Operating in Cold Temperature Climates. (Section 3-1.) 1. Turn key switch to RUN position. If engine coolant temperature is low, the engagement and monitor unit (EMU) will display a glow plug icon, text stating Wait to Start, and the count down of the seconds remaining before the engine should be started. IMPORTANT:

Avoid possible machine damage. Do not crank starter continuously for more than 45 seconds, or the starter may be damaged. If engine does not start within 45 seconds, turn key switch to OFF position and allow starter to cool for 1 minute before trying again. 2. Once countdown is completed, the EMU will display text stating Ready to Start Engine for 2 seconds, and then return to the normal run-time screen. Do not use ether or any other type of starting fluid on engines. 3. Turn key switch to the START position and release key when engine starts. Do not tow the machine to start it, or damage to hydrostatic system will occur.

OUT4001,0000524 -19-16SEP11-1/1 Engine Block Heater—If Equipped CAUTION: Prevent possible injury from electrical shock. Use grounded cord and inspect for damage before connecting to power source. TX1067048A —UN—29OCT09 IMPORTANT: Prevent property damage as a result of possible fire from an overheated electrical cord. Use a heavy-duty, grounded cord to connect heater to electrical power. Supply voltage for engine block heater can be 220 V or 110 V. Ensure the correct engine block heater is used for the correct supply voltage. Engine Block Heater Cord NOTE: Engine block heater is recommended when ambient temperature is below 5°F (-15°C).

1— Engine Block Heater Cord The engine block heater allows for quicker start and warmup during cold weather temperatures. Connect engine block heater cord (1) to electrical power a minimum of 4 hours before starting engine. LB82152,0000759 -19-04JAN13-1/1 2-2-4 071713 PN=56