Operation—Operating the Machine Manual Machine With Attachment Controls 4 7 8 5 1 6 2 TX1067177 —UN—04NOV09 TX1067181A —UN—02NOV09 3 Manual Machine With Attachment Controls Auxiliary Override, High Flow, and Aux. Fourth Function Switches For manual machine with attachment controls, use left and right control levers (1 and 2) to operate auxiliary hydraulic functions. Connect attachment to standard male and female couplers (12 and 13). Roll auxiliary proportional switch (4) forward or backward to vary hydraulic flow rate and direction depending on desired attachment function. Releasing the auxiliary proportional switch stops all auxiliary hydraulic flow.
TX1067105A —UN—02NOV09 To set continuous auxiliary flow, press and release auxiliary flow set switch (3) while the proportional switch is actuated in the desired direction. This will set the auxiliary hydraulics to run at full flow in the direction selected. Continuous auxiliary hydraulic flow will continue without pressing the auxiliary proportional switch. If continuous flow is active and the auxiliary proportional switch is moved in either direction or the flow set switch is pressed, continuous flow will be cancelled and proportional auxiliary hydraulic flow will resume.
High Flow and Attachment Control Shown 1— Left Control Lever 2— Right Control Lever 3— Auxiliary Flow Set Switch 4— Auxiliary Proportional Switch 5— Auxiliary Third Function A Switch (if equipped) 6— Auxiliary Third Function B Switch (if equipped) 7— Auxiliary Second Function A Switch (if equipped) 8— Auxiliary Second Function B Switch (if equipped) 9— Auxiliary Hydraulic Override Switch 10— High Flow Switch (if equipped) Auxiliary Fourth Function Switch (if equipped) 12— Standard Male Coupler 13— Standard Female Coupler 14— High Flow Male Coupler (if equipped) 15— High Flow Female Coupler (if equipped) 16— Attachment Case Drain Coupler (if equipped) 17— Electric 14-Pin Connector (if equipped) 18— Electric 3-Pin Connector (if equipped) If operator needs to exit the machine with hydraulics enabled, press upper half of auxiliary hydraulic override switch (9) momentarily to activate bypass mode.
The message, Auxiliary Override, will appear on engagement and monitor unit (EMU) display and alarm will sound. If attachment is equipped with electric 14-pin connector (17), use auxiliary second and third function switches 5, 6, 7, and 8 and auxiliary fourth function switch (11) to operate attachment. If attachment is equipped with electric 3-pin connector (18), use auxiliary third function switches to operate attachment. Consult attachment operator’s manual for attachment functions controlled by these switches. couplers (14 and 15), if equipped. Press upper half of high flow switch (10) momentarily to activate high flow option. Amber hydraulic high flow icon will appear on EMU. IMPORTANT:
Avoid attachment damage. Only use high flow switch (10) with high flow attachments. NOTE: Attachment case drain coupler (16) is only used when required by attachment. If attachment requires a high hydraulic flow rate to operate, connect attachment to high flow male and female Continued on next page OUT4001,0000530 -19-31JAN13-2/3 2-2-19 071713 PN=71