John Deere 326D, 328D, 332D — Using Attachment Mounting System—Quik-Tatch™

Operation—Operating the Machine Using Attachment Mounting System—Quik-Tatch™ Manual Quik-Tatch™ TX1067234A —UN—03NOV09 CAUTION: Prevent possible injury from unexpected machine movement. Be careful not to pinch hands between latch handle and step or latch handle and attachment. DO NOT try to latch or unlatch handles from operator's station. Installing an attachment: 1. Park machine on level surface. Manual Quik-Tatch™ 2. Lift latch handles (1) up to unlatched position. Be sure latch handles are all the way up so lock pins are fully retracted. 1— Latch Handle (2 used) 2— Mounting Plate (2 used) 3— Mounting Bracket (2 used) 3. Enter machine, fasten seat belt, and lower interlocking seat bar.

Start engine. Disengage park brake. IMPORTANT: Avoid excessive pin wear. Keep the pin area clear of dirt and debris. If the pin will not fully engage or if wear is detected, see your authorized dealer. 4. Tilt mounting plates (2) forward. 5. Drive forward. Raise boom and guide top of mounting plates under attachment mounting brackets (3). 6. Raise and roll back mounting plates. The back of attachment should rest against front of mounting plates. 15. Before connecting hydraulic hoses, relieve hydraulic system pressure. See Hydraulic System Pressure Release. (Section 2-2.) 7. When attachment is fully supported, lower boom until boom is resting on boom stops. 16.

Connect attachment hydraulic hoses and electrical connections to machine, if equipped. 8. Roll attachment out, stopping with bottom edge of attachment about 50 mm (2 in.) from ground. Removing the attachment: 1. Park machine. 9. Engage park brake, stop engine, raise interlocking seat bar, unfasten seat belt and exit machine. CAUTION: Prevent possible crushing injury from falling attachment. Be sure attachment is on the ground before continuing. 10. Push the two latch handles down to lock attachment to Quik-Tatch™. 11. Enter machine, fasten seat belt, and lower interlocking seat bar. 2. Lower boom until attachment is securely resting on ground. 3.

Disconnect hydraulic hoses from couplers, if needed. 12. Start engine and disengage park brake. 4. Pull latch handles up to unlatched position to release pins from lower attachment tabs. Be sure latch handles are fully raised. 13. Activate boom cylinders to raise attachment and extend bucket cylinders to tilt attachment at a slight downward angle so that bottom of Quik-Tatch™is visible. 5. Enter machine, fasten seat belt, and lower interlocking seat bar. CAUTION: Prevent possible crushing injury from falling attachment. Be sure pins and latch handles are secure before operating boom and bucket. 6. Start engine and disengage park brake. 7.

Tilt mounting plate forward and back machine away from attachment at the same time. If attachment is not securely latched, follow the removal procedure, and then repeat installation procedure. 14. Visually inspect attachment mechanism to verify that pins are fully engaged in slots on back of attachment. Quik-Tatch is a trademark of Deere & Company Continued on next page OUT4001,0000532 -19-23MAR11-1/2 2-2-23 071713 PN=75